If your order is being shipped to an address outside of the United States, local consumer tax and/or customs duty may apply. We will send you an Etsy link to pay for the additional shipping to these areas if applicable. Additional Shipping Fee(s) may apply for International, HAWAII, ALASKA & PUERTO RICO. We will send you an Etsy link to pay for the additional shipping to these areas. NOTE: $75.00 Additional Shipping Fee (each item) for International, HAWAII, ALASKA & PUERTO RICO. ★ Top shelf is great for storing drill bits, charging stations, measuring tapes, screwdrivers. (Makita, Dewalt, Dewalt 20V MAX, Kobalt, Ryobi, Bosch, Milwaukee, Craftsman, Rigid, Hilti) ★ Slots fit most manufacture's impact guns, drills, staple guns. ★ Made with pride in the USA | Bush Acres Quality! All pieces slot together, assembly screws included. ★ Assembly required - Very easy to put together. ★ Organizer is 11" deep x 14.5" tall x 21.5" wide ★ Made from 1/2" Birch Plywood | Hand Sanded Much more convenient now.5 TOOL WOOD CRAFTED ELECTRIC DRILL ORGANIZER CABINET All these tools used to be spread across the work bench. You could mount the tubes in a vertical orientation as well as long as they don’t rest on the triggers. I also made one for the RIDGID oscillating multi-tool because I use it all the time. I did that so I can leave bits mounted in them. I mounted mine to the underside of a shelf about 6″ from the wall. It will have to be a hair wider than the long tip on the impact or hand driver. The third hole is an access hole for the screwdriver. In the picture you’ll notice 3 holes drilled in each piece. Some may need additional sanding if the fit is too tight. This is a great time to check the fit with all your drills or impact drivers. If you don’t have a drill press this would be a great project to justify it’s purchase with your significant other! The Skil benchtop or Ridgid floorstanding press would be an excellent choice. If you chose ABS than it has a lower melt point so you may have to sand even slower. If using a drill press or cordless drill go slow enough not to melt the plastic. If you have a drill press set the table height so that you don’t have to lift the piece. Use something aggressive like 60 or 80 grit to make this step go faster. Step 6: Clean up the slot with a 1-1/2″ drum sander or sanding block. It’s ok if your lines are not the straightest, they’ll be cleaned up in the next step. Take your time, cut level, part of the jigsaw base will be suspended in the air. Step 5: Cut the straight lines with the Jigsaw or Oscillating Multi-tool. A hole bit is preferred but I couldn’t find my 1-1/2″ size when I made this. I used a spade bit but eye protection is definitely needed. Step 4: Use a 1-1/2″ bit to drill the rounded part of the slot. Step 3: Secure 8″ section in vise (or screw it down to the workbench) and mark a 1-1/2″ slot 5″ deep and round over the end. Miter saw will cut it faster and straighter but recip will work too. Step 2: Cut pipe with Miter or Reciprocating saw. You could also use black ABS pipe but it’s more expensive and the melt point is lower so you would have to sand slower. Home Depot sells these sections for just a few bucks. Step 1: Buy 2′ section of 3″ PVC pipe and mark it at 8 and 16 inches with sharpie.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |